Pervious Concrete as a Controlled Stormwater Capture-Pretreatment Interface in a School-Scale Decentralized Harvesting System.
Source: PubMed, NCBI / U.S. National Library of Medicine
Urban stormwater is often viewed as a drainage problem rather than a local water resource, even in areas where runoff capture could simultaneously reduce flooding and promote the reuse of non-potable water. This study develops, installs, and field-tests a decentralized, school-scale stormwater harvesting system that relocates permeable concrete, transforming it from a passive infiltration surface into a purpose-built capture and pretreatment interface. The system integrates a 3 m × 3 m permeable concrete slab with load-bearing sections, an impermeable underlayer to ensure controlled flow, a double-compartment sump for staged sedimentation and hydraulic damping, sequential filtration with sand/gravel and activated carbon, and a 5000 L storage tank. The prototype was implemented at CETis 105 in Querétaro, Mexico, and evaluated during its commissioning and operation in the 2023 rainy season. Field operations demonstrated reduced ponding in the catchment area and a reliable flow of runoff to the pretreatment units. In the sump compartments, apparent color decreased from 221 to 59 Pt-Co, turbidity from 46.8 to 12.9 NTU, and COD from approximately 30-35 to 15-18 mg·L, corresponding to approximate pretreatment reductions of 73.3%, 72.4%, and 40-57%, respectively, before post-filtration. Conversely, the elevated pH, electrical conductivity, and total dissolved solids indicated interaction with fresh cementitious materials and dissolved ionic residues during initial ope
Abstract
Urban stormwater is often viewed as a drainage problem rather than a local water resource, even in areas where runoff capture could simultaneously reduce flooding and promote the reuse of non-potable water. This study develops, installs, and field-tests a decentralized, school-scale stormwater harvesting system that relocates permeable concrete, transforming it from a passive infiltration surface into a purpose-built capture and pretreatment interface. The system integrates a 3 m × 3 m permeable concrete slab with load-bearing sections, an impermeable underlayer to ensure controlled flow, a double-compartment sump for staged sedimentation and hydraulic damping, sequential filtration with sand/gravel and activated carbon, and a 5000 L storage tank. The prototype was implemented at CETis 105 in Querétaro, Mexico, and evaluated during its commissioning and operation in the 2023 rainy season. Field operations demonstrated reduced ponding in the catchment area and a reliable flow of runoff to the pretreatment units. In the sump compartments, apparent color decreased from 221 to 59 Pt-Co, turbidity from 46.8 to 12.9 NTU, and COD from approximately 30-35 to 15-18 mg·L, corresponding to approximate pretreatment reductions of 73.3%, 72.4%, and 40-57%, respectively, before post-filtration. Conversely, the elevated pH, electrical conductivity, and total dissolved solids indicated interaction with fresh cementitious materials and dissolved ionic residues during initial operation, highlighting the need for curing, initial washing, and post-filtration verification before declaring compliance with reuse requirements. Therefore, the results support the feasibility of the proposed configuration as a decentralized, low-infrastructure architecture for localized runoff control and pretreatment, while confirming that full reuse validation still requires microbiological and post-filtration evaluation. The study provides a field-proven system design adaptable to school campuses and similar institutional environments for distributed stormwater management and non-potable water storage.